low on-resistance wideband/video quad 2-ch 1 idtvs330 confidential datasheet confidential general description the idtvs330 is a true bidirectional quad 2-channel multiplexer/ demultiplexer recommended for both rgb and composite video switching app lications. the video switch can be driven from a current output ramdac or voltage output composite video source. low on-resistance and wide bandwidth make it ideal for video and other applications . also this device has exceptionally high current ca pability which is far greater than most analog switches offered today. a single 5v supply is all that is required for operation. the idtvs330 offers a high-per formance, low-cost solution to switch between video sources. the application section describes the idtvs330 replacing the hc4053 multiplier and buffer/ amplifier. features ? high-performance solution to switch between video sources ? wide bandwidth: 600mhz ? low on-resistance: 5 ? typical ? low crosstalk at 10mhz: ?80db ? ultra-low quiescent power (0.1 a typical) ? fast switching: 10ns ? 8kv esd hbm on connector side ? available in soic and qsop packages block diagram en in s1a s2a s1b s2b s1c s2c s1d s2d da db dc dd selector logic low on-resistance wide band/video quad 2-ch idtvs330 7012/6
idtvs330 low on-resistance wideband/video quad 2-ch commercial temperature range low on-resistance wideband/video quad 2-ch 2 idtvs330 7012/6 confidential pin configuration absolute maximum ratings truth table soic/ qsop top view in s1a s2a da s1b s2b db gnd v cc en s1d s2d dd s1c s2c dc 1 2 3 4 5 6 7 8 16 15 14 13 12 11 10 9 symbol rating min max 1 unit tstg storage temperature range ? 65 +150 c ambient temperature with power applied 0 +70 c supply voltage to gnd potential ? 0.5 +5.5 v dc input voltage ? 0.5 +5.5 v dc output current ? 120 ma power dissipation ? 0.5 w 1. stresses greater than those listed under absolute m aximum ratings may cause permanent damage to the device. this is a stress rating only and functiona l operation of the device at these or an y other conditions above those indicated in the operational sections of this spec ification is not implied. exposure to abs olute maximum rating conditions for extend- ed periods may affect reliability. en in on switch l l s1a, s1b, s1c, s1d l h s2a, s2b, s2c, s2d h x disabled
idtvs330 low on-resistance wideband/video quad 2-ch commercial temperature range low on-resistance wideband/video quad 2-ch 3 idtvs330 7012/6 confidential pin description dc electrical characterist ics over operating range following conditions apply un less otherwise specified: t a = 0c to +70c, v cc = 3.3v 5%. name function s1, s2 analog video i/os in select input en enable d analog video i/o gnd ground v cc power supply symbol parameter conditions 1 min. typ. 2 max. unit v analog analog signal range 0 ? v cc v v ih input high voltage guaranteed logic high level 2 ? ? v v il input low voltage guaranteed logic low level 0 ? 0.8 i ih input high current v cc = max., v in = v cc ??1 a i il input low current v cc = max., v in = v ss ??1 i o analog output leakage current 0 s1, s2 or d v cc , switch off ? ? 1 a v ik clamp diode voltage v cc = min., i in = -18ma ? 0.7 ? 1.2 ? v v h input hysteresis at control pins ? 150 ? mv r on 3 switch on-resistance v cc = min., v in = 1v, i on = 13ma ? 5 7 ? v cc = min., v in = 2v, i on = 26ma ? 7 10 1. for max. or min. conditions, use appropr iate value specified under electrical c haracteristics for the applicable device type. 2. typical values are at v cc = 3.3v,t a = 25c ambient and maximum loading. 3. measured by the voltage drop between s1, s2, and d i/o pins at indicated current through the switch. on-resistance is determined by the lower of the voltages on the s1, s2, and d i/o pins.
idtvs330 low on-resistance wideband/video quad 2-ch commercial temperature range low on-resistance wideband/video quad 2-ch 4 idtvs330 7012/6 confidential dynamic electrical character istics over operating range following conditions apply un less otherwise specified: t a = 0c to +70c, v cc = 3.3v 5%. dc electrical characterist ics over operating range following conditions apply un less otherwise specified: t a = 0c to +70c, v cc = 5v 5%. symbol parameter conditions min. typ. max. unit t on turn on time r l = 75 ? , c l = 20pf ? 2.5 5 ns t off turn off time r l = 75 ? , c l = 20pf ? 1.1 5 b w 1 ?3db bandwidth ? ? 570 mhz x talk 1 crosstalk 10mhz, c l = 0pf ? ? 80 ? db c in 1 input/enable capacitance v in = 0v, f = 1mhz ?? 6 pf c off 1 capacitance, switch off ? ? 6 c on 1 capacitance, switch on ? ? 9 o irr off isolation 10mhz, c l = 0pf ? ? 48 ? db 1. this parameter is determined by device ch aracterization but is not production tested. symbol parameter conditions 1 min. typ. 2 max. unit v analog analog signal range 0 ? v cc v v ih input high voltage guaranteed logic high level 2 ? ? v v il input low voltage guaranteed logic low level ? 0.5 ? 0.8 i ih input high current v cc = max., v in = v cc ??1 a i il input low current v cc = max., v in = v ss ??1 i o analog output leakage current 0 s1, s2 or d v cc , switch off ? ? 1 a v ik clamp diode voltage v cc = min., i in = -18ma ? 0.7 ? 1.2 ? v i os 3 short circuit current 100 ? ? ma v h input hysteresis at control pins v cc = min., v in = 1v, r l = 75 ? , i on = 13ma ? 150 ? mv r on 4 switch on-resistance v cc = min., v in = 2v, r l = 75 ? , i on = 26ma 3 7 10 ? 1. for max. or min. conditions, use appropriate value specifi ed under electrical characterist ics for the applicable device type. 2. typical values are at v cc = 5v, t a = 25c ambient and maximum loading. 3. not more than one output should be shorted at one time. duration of the test should not exceed one second. 4. measured by the voltage drop between s1, s2, and d i/o pins at indicated current through the switch. on-resistance is determined by the lower of the voltages on the s1, s2, and d i/o pins.
idtvs330 low on-resistance wideband/video quad 2-ch commercial temperature range low on-resistance wideband/video quad 2-ch 5 idtvs330 7012/6 confidential dynamic electrical character istics over operating range following conditions apply un less otherwise specified: t a = 0c to +70c, v cc = 3.3v 5%. power supply characteristics symbol parameter conditions min. typ. max. unit t on turn on time r l = 75 ? , c l = 20pf ? 2.5 5 ns t off turn off time r l = 75 ? , c l = 20pf ? 1.1 5 b w 1 -3db bandwidth r l = 150 ? ? ? 570 mhz x talk crosstalk r in = 10 ? , r l = 150 ? , 10mhz ? ? 58 ? db d g differential gain r l = 150 ? , f = 3.58mhz ? 0.64 ? % d p differential phase r l = 150 ? , f = 3.58mhz ? 0.27 ? deg. c in 1 input/enable capacitance v in = 0v, f = 1mhz ?? 6 pf c off 1 capacitance, switch off ? ? 6 c on 1 capacitance, switch on ? ? 8 o irr off isolation r l = 150 ? , 10mhz ? ? 38 ? db 1. this parameter is determined by device characterization but is not production tested. symbol parameter conditions 1 min. typ. 2 max. unit i cc quiescent power supply current v cc = max., i n = gnd or v cc ?0.1 3 a ? i cc power supply current per input @ ttl high v cc = max., i n = 3.4v 3 ??2.5 ma i ccd 4 supply current per input per mhz v cc = max., s1, s2 and d pins open, en = gnd control input toggling, 50%duty cycle ? ? 0.25 ma/mhz 1. for max. or min. conditions, use appropriate value specif ied under electrical characteristics for the applicable device. 2. typical values are at v cc = 5.0v, +25c ambient. 3. per ttl driven input (v in = 3.4v, control inputs only); s1, s2, and d pins do not contribute to i cc . 4. this current applies to the control inputs only and represent th e current required to switch in ternal capacitance at the spec - ified frequency. the s1, s2, and d i/o pins generate no signifi cant ac or dc currents as they transition. this parameter is not tested, but is guaranteed by design.
idtvs330 low on-resistance wideband/video quad 2-ch commercial temperature range low on-resistance wideband/video quad 2-ch 6 idtvs330 7012/6 confidential test circuit for electrical characteristics figure 1. switching time test circuit for dynamic electrical characteristics figure 2. gain/phase, crosstalk, off-isolation v cc v cc v out 3v s in gnd en d 75 ? 20pf t on t off analog output digital input 50% 90% 50% 90% hp4396b r1 t1 s1 hp11667a idtvs330 c l
idtvs330 low on-resistance wideband/video quad 2-ch commercial temperature range low on-resistance wideband/video quad 2-ch 7 idtvs330 7012/6 confidential figure 3. bandwidth vs load 700 600 500 400 300 200 100 0 0 1020304050 load, pf bandwidth, mhz
idtvs330 low on-resistance wideband/video quad 2-ch commercial temperature range low on-resistance wideband/video quad 2-ch 8 idtvs330 7012/6 confidential package dimensions - soic 150 mil (narrow body) soic n index area 12 d h e1 c l h x 45 a a1 b e .10 (.004) seating plane symbol in millimeters common dimensions in inches common dimensions 1 min max min max a 1.35 1.75 .0532 .0688 a1 0.10 0.25 .0040 .0098 b 0.33 0.51 .0130 .0200 c 0.19 0.25 0075 .0098 d 9.80 10.00 .3859 .3937 e 3.80 4.00 .1497 .1574 e 1.27 basic 0.050 basic h 5.80 6.20 .2284 .2440 h 0.250.50.010.020 l 0.401.27.016.050 n16 16 0 8 0 8 1. for reference only. controlling dimensions are in mm.
idtvs330 low on-resistance wideband/video quad 2-ch commercial temperature range low on-resistance wideband/video quad 2-ch 9 idtvs330 7012/6 confidential package dimensions - qsop 150 mil ssop (qsop) n index area 12 a2 d a a1 b e 10 (.004) - c - seating plane c e e1 c l zd symbol in millimeters common dimensions 1 in inches common dimensions min max min max a 1.351.75.053.069 a1 0.10 0.25 .004 .010 a2 ? 1.50 ? .059 b 0.200.30.008.012 c 0.180.25.007.010 d 4.80 5.00 .189 .197 e 5.806.20.228.244 e1 3.80 4.00 .150 .157 e 0.635 basic 0.025 basic l 0.401.27.016.050 n16 16 0808 zd .23 ref .009 ref 1. for reference only. controlling dimensions are in inches.
idtvs330 low on-resistance wideband/video q uad 2-ch commercial temperature range ? 2007 integrated device technology, inc. all rights reserved. product specifications subject to change without notice. idt and the idt logo are trademarks of integrated device technology, inc. accelerated thinking is a service mark of integrated device technology, inc. all other brands, product names and marks are or may be trademarks or registered trademarks used to identify products or services of their respective owners. printed in usa corporate headquarters 6024 silver creek valley road san jose, ca 95138 for sales: 800-345-7015 or 408-284-8200 fax: 408-284-2775 www.idt.com for tech support: email: videohelp@idt.com ordering information idtvs xxxx device type xx package x temp. range x shipping carrier 8 blank blank dcg 330 tape and reel tray commercial (0c to +70c) low on-resistance wideband/video quad 2-channel mux/demux shrink outline ic -green qg quarter-sized shrink outline package - green
|
